automotive vinyl wrap suppliers How to fix wrinkles on vehicle wrap film when you have to pick the panel up
Sometimes your vehicle wrap film can get really browned, especially if you're a beginner installer. Sometimes it can be difficult to pick up a panel that is already attached to the vehicle's body.
Today, we will discuss how to remove wrinkles from vehicle wrap film that is already on the body and how to squeegee the film back down to smooth it out.
Let's take as an example, a piece of vehicle wrap film that covers both the doors. It goes literally from top to bottom. There are also wrinkles around the gap that you cannot see unless you get close enough. Worse, those wrinkles can't be popped because they are just clumped together.
Car VinylWrap
Instead of trying to fix the wrinkles by picking up the entire panel, it is better to cut through the space between the doors. automotive vinyl wrap suppliers This will save you a lot of trouble and make it easier for you to pick up the vehicle wrap film. Rule number 1: Don't try to separate the entire panel.
After it has been divided into two sections, wrap the vehicle film from the bottom. The film will remain attached to the body so that wrinkles do not form. automotive vinyl wrap suppliers Lift the material upwards and pull evenly from the bottom to the top. This is necessary to trigger the memory of film and allow wrinkles to disappear.
Remember, your free hand should not stretch the material, but simply keep it away. You might stretch it too much.
Vehicle wrap films with PVC or memory can self-heal. This is our goal. The tension will appear as you grab the material. Then, heat the material and let it relax. Let the film cool down.
Your free hand shouldn't be pulled or stretched. Simply let the film cool and relax while you hold it. automotive vinyl wrap suppliers The panel will become smoother and the tiny wrinkles will disappear as they are self-healed with heat.
Now the problem is: without backing paper and vehicle wrap film being removed again, how do we get it flat and straight?
It is important to use both your hands in conjunction. Your right hand will be used to rub the vehicle wrap film. While your free hand will create glass, your left hand will do that. As we have mentioned, you should squeegee at 45 degrees. Don't use more than a quarter of your squeegee. There would be tension otherwise.
You can squeezegee each section until you get to the point that glass is created from left to right. This is where patience and the ability to read your film are crucial. www.vinylcarwrapshop.com automotive vinyl wrap suppliers Make sure you read your vehicle wrap film carefully and make a decision about what you can and cannot do. Then, use your squeegee to apply the appropriate pressure. Give it a bit more heat and wait for it to cool down before you start again to remove the material.
Let's say that in order to fix wrinkles, you need to first determine if you can separate the panel into smaller pieces so you can lift it easily. Then, activate the memory of your film and use heat to relax it. Finally, self-heal it. You can then finish by squeegeeing down enough of your squeegee. automotive vinyl wrap suppliers Read the wrinkles and follow the instructions.
These steps will help you to easily manage wrinkles. It shouldn't be difficult to pick the panel up again.
Tips for wrapping your car
How to Fix Winkles
How to wrap a car
Installation
TeckWrap
Wrap tips
